Viking Professional Induction Range Codes 1-10: LED code table for the VISC530

What 1-10 (induction range) means

On the Viking Professional 30-inch induction range VISC530, such as the VISC530-4B, the induction section reports problems through a numbered LED code. The table matches the one used on other Viking induction platforms: 1 pan or residual heat, 2 switch, 3 flash failure, 4 setup data, 5 communication, 6 filter board, 7 voltage supply, 8 unassignable code, 9 temperature sensor, 10 wrong terminal voltage above 400 V. The number tells us which part of the induction system to test.

Common causes of 1-10 (induction range)

Code 1: a pan that is hot or residual heat on the surface, which is a normal protective response
Codes 2, 3 and 4: a switch, a flash memory or setup data problem on the induction electronics
Codes 5 and 6: communication or filter board trouble between the induction boards
Codes 7 and 10: supply voltage that is out of range or wired to the wrong terminals
Codes 8 and 9: an unassignable code or a temperature sensor reading that does not make sense

✓ One safe check you can try

1. Switch the burner off and let the surface and pan cool. 2. Note the LED number exactly as it shows. 3. Reset the range breaker by turning it off, counting to sixty, and turning it on again. 4. Use a flat, magnetic pan that fits the zone. 5. For codes 7 and 10, do not touch the terminals; call us. If any number repeats, call us with it.

! Why to stop there

Each number points to a different part of the induction electronics, so the exact number matters more than how the surface behaves
Codes about voltage and terminals involve live range wiring that only a qualified technician should check
Replacing induction boards on a guess is expensive

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

DSI 1 FlashViking Range Code DSI 1 Flash: Normal Ignition Module Heartbeat Red backlight / flashing knob ringsViking 7 Series Range Alert: red backlight and flashing knob rings DSI 2 or 5 FlashesViking Range Code DSI 2 or 5 Flashes: Ignition Control Problem RTD ProbViking VDSC Range Code RTD Prob: Oven Sensor Open or Shorted DSI 3 FlashesViking Range Code DSI 3 Flashes: Ignition Lockout, No Flame Detected Runaway Oven TemperatureViking VDSC548T Code Runaway Oven Temperature: Small Oven Far Above Set Point DSI 4, 6 or 8 FlashesViking Range Code DSI 4, 6 or 8 Flashes: Gas Solenoid Problem DSI 7 FlashesViking Range Code DSI 7 Flashes: Power Applied With a Knob On

1-10 (induction range)1-10 (induction range) questions

Does every number on this table mean a breakdown?

No. Code 1 is simply pan or residual heat protection and clears when things cool. The others describe the electronics or supply, and those need a technician if they return after a restart.

What should I tell you when I call?

Give us the number shown, the full model such as VISC530-4B, and what you were doing when it appeared. That lets us bring the right boards and check the supply first.

Can you fix the voltage codes?

Codes 7 and 10 involve the supply and terminal connections, so we check those with a meter first. You get a written price before work, and repairs carry a 30-day workmanship warranty.