Viking Range Oven Code RTD: oven probe error on indicator-light ovens

What RTD means

On Viking indicator-light range ovens without a numeric display, such as the Professional VDSC530 and VESC530 and the D3 RDSCD230-5B, the RTD message is an oven probe error. The cycle light flashes one second on and one second off while the clean light stays off. The RTD is the probe that measures oven temperature, so the control cannot hold or confirm a set temperature.

Common causes of RTD

Oven temperature probe open or shorted
Probe wiring or connector damaged
Control not reading the probe

✓ One safe check you can try

1. Switch the oven off and let it cool. 2. Turn the oven's breaker off for a minute, then back on. 3. Try a short bake at a low temperature and watch the lights. 4. If the cycle light flashes again, stop using the oven. If you have a dual-fuel range and notice a gas smell, leave and call the gas utility from outside.

! Why to stop there

Probe testing needs a meter
The probe is inside the cavity and its connector behind the wall
We quote first in writing, with a 30-day warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

F09Viking EOC4 Wall Oven Code F09: runaway oven temperature above 650F no probe (flashing)Viking Premiere Knob-Control Oven Message "no probe": probe function started without probe F1Viking ERC Oven Code F1: control malfunction on VGDO271 and VEDO273, shorted probe on VGSO166 PROBE ERRORViking Touch-Control Wall Oven Message "PROBE ERROR": meat probe open or shorted F2Viking ERC Oven Code F2: over-temperature on VGDO271 and VEDO273, open probe on VGSO166 RELAY ERRORViking Touch-Control Wall Oven Message "RELAY ERROR": no relay board connection F3Viking ERC Oven Code F3: oven sensor open on VGDO271 and VEDO273, controller malfunction on VGSO166 RTD ERRORViking Touch-Control Wall Oven Message "RTD ERROR": oven temperature sensor open or shorted

RTDRTD questions

What is the RTD pattern?

The cycle light flashes evenly, one second on and one second off, with the clean light off. That pattern tells you the oven probe is the issue.

Is the probe easy to replace?

It is a straightforward part for a technician, but it connects behind the oven wall. We test it with a meter before ordering anything, then quote the price.

Will the oven heat with the RTD pattern?

It may not heat reliably, since the control has no usable temperature reading. Wait for the repair before relying on the oven for a meal.