Viking Built-In Dishwasher Code Pressure Sensor Disconnect (2-1): Huba sensor not detected

What Pressure Sensor Disconnect Error means

Flash pattern 2-1, two Pots/Pans blinks followed by one Normal Wash blink, is listed as a Huba Disconnect Error on Viking Professional VDB450 and Designer DDB325 built-in dishwashers. The Huba sensor reports the water condition in the tub, and the control can no longer see it. Without that reading the control will not run the cycle safely, so it stops and flashes.

Common causes of Pressure Sensor Disconnect Error

Huba sensor connection loose or open
Sensor or its wiring damaged
Control not detecting the sensor

✓ One safe check you can try

1. Turn off the dishwasher's breaker for two minutes and restore power. 2. Run a short cycle and see whether the 2-1 pattern appears again. 3. If it does, stop using the machine. The sensor and its connector are inside the unit, so please do not pull the dishwasher out or remove panels. Call us with your model number.

! Why to stop there

A disconnected sensor needs the unit opened to inspect the plug and wiring
If the sensor itself is bad, we confirm that first
Price in writing before we start, with a 30-day warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

Moisture SensorViking Built-In Dishwasher Message "Pan Flood": moisture sensor detects water in the base pan Moisture Sensor DisconnectViking Built-In Dishwasher Code Pan Flood Sensor Disconnect (1-1): flood sensor not connected Motor Control Comms ErrorViking Built-In Dishwasher Code Motor Control Comms Error (1-3): motor control not answering Motor Control Status ErrorViking Built-In Dishwasher Code Motor Control Status Error (1-2): motor control reports a problem Motor Status ErrorViking Built-In Dishwasher Code Motor Status Error (3-4): wash motor status reported Motor Under Voltage ErrorViking Built-In Dishwasher Code Motor Under Voltage Error (3-5): motor supply too low E:09Viking Dishwasher Code E:09: display board communication problem Pots/Pans + Heavy FlashingViking Designer Dishwasher Code Pots/Pans + Heavy Flashing: blocked drain

Pressure Sensor Disconnect ErrorPressure Sensor Disconnect Error questions

What does the Huba sensor do?

It gives the control a reading of the water in the tub. Pattern 2-1 means the control lost contact with it, so it cannot judge the level.

Is it only a loose plug?

Often it is a connection, but we test before assuming anything. If the sensor itself is bad, we quote the part and the labor in writing first, before we order it.

Will this stop all cycles?

Usually yes, because the control wants the water reading before it fills and washes. Reset the power once at the breaker, and call us if the pattern returns afterward.