Viking Incogneeto Warmer Code E-10: Magneeto II RTD failure

What E-10 means

On the Viking Incogneeto under-counter induction warmer VUIW518, E-10 means the Magneeto II RTD has failed. The RTD is a temperature sensor in the warming element that the unit uses to read heat. When it fails, the device needs service. This is a sensor failure inside the heating assembly. The warmer stops and shows the code, since it cannot hold a safe temperature without the reading.

Common causes of E-10

A Magneeto II RTD sensor that has failed
A damaged or loose connection to the RTD
A control that cannot read the sensor

✓ One safe check you can try

1. Turn the warmer off, then give it time to cool. 2. Unplug it for five seconds and plug it back in. 3. Make sure the air openings are clear. 4. Try one short cycle. 5. If E-10 returns, leave the unit off and call us.

! Why to stop there

The RTD sits in the heating assembly and needs a meter
Without it the unit cannot hold temperature
Replacing the wrong part adds cost

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Warming Drawer codes

E-01Viking Incogneeto Warmer Code E-01: broken temperature sensor E-03Viking Incogneeto Warmer Code E-03: over current peak, try different cookware E-06Viking Incogneeto Warmer Code E-06: high line voltage E-07Viking Incogneeto Warmer Code E-07: hardware failure E-08Viking Incogneeto Warmer Code E-08: zero cross failure E-16Viking Incogneeto Warmer Code E-16: critical error, service required

E-10E-10 questions

What is the Magneeto II RTD?

It is the temperature sensor in the Magneeto II warming element. The unit reads it to hold food at the right warmth, so its failure stops the unit.

Is E-10 the same as E-01?

They are related but separate codes. E-01 is the broken temperature sensor, while E-10 names the Magneeto II RTD specifically. Both need service, and we test which one applies.

What will it cost?

We test the sensor and its connection first and quote the price in writing before any work. The repair carries a 30-day workmanship warranty from the day of the visit.