Viking DTWN48481 Tall Hood Repair
The DTWN48481 is the 48-inch size in the Designer Series tall traditional wall hood family, made without a ledge. It is typically hung above a 48-inch range, and the width allows the canopy to cover the burners and a griddle.
A wide range creates a lot of steam, so the first thing we examine is how well the filters are holding up. We remove and clean them, then open the housing to examine the blower. The motor is tested on each speed, the duct damper is checked and the lamps are replaced where needed. If the controls are unreliable we follow the wiring back from the switch. The final test is a run at each speed, with the lights on, to confirm the canopy draws evenly.
We quote in writing before beginning. Repairs carry a 30-day workmanship warranty.
That often means grease is concentrated in the filters at one end, or the canopy is not drawing evenly. We clean and reseat them first.
No, but we keep the burners off and cool while we work above them. We also clear the cooktop of pans. Cleaning the filters and checking the damper is the first step in that case, and it often restores an even draw.
It is, so we work with the chimney supported and with care around the finish. Most work is done in place. We simply ask that the cooktop is cool and clear of pans while we work above it, then check it again at the end.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
